Noritz tankless water heater repair service Maintenace tankless flushing Ontario. 

(905) 403-9914

Noritz Tankless hot water heater repair services in Toronto Mississauga, Oakville, Burlington, Etobicoke maintenace and installation in Ontario areas. 

Trouble shooting and error codes for Noritz tankless water heater. 

THE SEVEN MOST COMMON NORITZ TANKLESS ERROR CODES

NORITZ ERROR CODE 11

This indicates ignition failure in your tankless water heater. It means that your unit is not firing up to heat the water, a situation that can be caused by insufficient gas supply, insufficient airflow or debris on the ignition plug.

After checking to see if the gas is turned on, call a licensed contractor. He or she will make sure your gas valve is open, the exhaust vent is unobstructed and the ignition plug is firmly attached and free of debris.

NORITZ ERROR CODE 12

A code 12 means the unit has a weak flame and that water is not being heated properly. Similar to a code 11, this is caused by lack of gas or airflow.

Call your licensed contractor who will likely take similar steps as outlined for code 11.

NORITZ ERROR CODE 16

A sharp spike in outlet water temperature will cause a code 16. This often results from scale buildup, which hampers heat-transfer efficiency and makes the unit try to compensate by burning hotter.

Since this error can be caused by scale buildup or hard water, performing a descaling procedure
or using a water softener may resolve it. Contact your licensed contractor to make sure this is the case.

NORITZ ERROR CODE 29

This code indicates a problem with condensate drainage. In condensing tankless water heaters, a special drain line equipped with a neutralizer (to reduce the acidity of the outflow) removes the condensate. A blockage in the condensate drain line or incorrect condensate drain piping would cause the burner to flood if not for this error code.

Call your licensed contractor, and he or she will check to make sure the condensate drain line is properly routed and unobstructed.

NORITZ ERROR CODE 73

Improper circuit board settings will cause a code 73 error. Changing a jumper connection or dip switch while power is supplied to the heater can trigger the problem, as can an improperly programmed circuit board.

Unplug the heater for 30 seconds and then plug it back in. If the error code persists, call a licensed contractor.

NORITZ ERROR CODE F76

This error code involves a breakdown in communication between two tankless water heaters using the Quick Connect Cord. It can occur when more than one remote is hooked up to handle two Quick-Connected units.

Make sure that only one remote control is hooked up when two units are connected. If the error continues, contact a licensed contractor.

NORITZ ERROR CODE 90

A code 90 indicates a combustion abnormality caused by an improper mixture of air and fuel. Possible culprits are insufficient gas supply, a blockage in the fuel vent or debris in the fan motor.

You will need a licensed contractor to resolve this error. He or she will check gas pressures, venting length, dip switches, etc.

For repair services call 905 403-9914 installation anmd maintenace trouble shooting. Error codes for Noritz tankless water heaters. 

Noritz tankless water heater repair service maintenace and installation in Ontario.Services in Toronto Mississauga , Oakville, Burlington, Etobicoke, Milton, George Town.